Catatan: ArduIMU bukan Autopilot, hanya merupakan solusi orientasi (jantung dari Autopilot) dan dapat digunakan pada projek apapun yang anda inginkan, Perahu boat, Mobil, Roket, atau bahkan ajing anda.Untuk mempelajari lebih tentang IMU, anda dapat membacanya disini.
Fitur ArduIMU V3 baru terdapat MPU-6000 termasuk 3 axis gyros & accells built-in, Fitur terbaru terdapat 3 axis I2C magnetometer HMC-5883L dan Arduino Atmega328 16Mhz.
MPU-6000 menggunakan SPI untuk maximum performa.
Spesifikasi:
- Tri-Axis angular rate sensor (gyro) with a sensitivity up to 131 LSBs/dps and a full-scale range of ±250, ±500, ±1000, and ±2000dps
- Tri-Axis accelerometer with a programmable full scale range of ±2g, ±4g, ±8g and ±16g
- Reduced settling effects and sensor drift by elimination of board-level cross-axis alignment errors between accelerometers and gyroscopes
- Digital Motion Processing™ (DMP™) engine offloads complex MotionFusion, sensor timing synchronization and gesture detection with supported software (not yet currently supported in DIY Drones code)
- Full Chip Idle Mode Supply Current: 5µA
- On-chip timing generator with ±1% frequency variation over full temperature range
- User self test
- 10,000g shock tolerant
ArduIMU V3 Fitur:
- Pin compatible with ArduIMU V2.
- Breadboard compatible (ArduIMU V2 was not!).
- Smaller size (1.5" x 1.0").
- Atmega CPU has more % available for other tasks.
- The 6 analog pins are now available!
- Arduino compatible and open source.
- 3 status LED's (RGB).
- I2C port with 3.3V translation.
- GPS port with FTDI autoswitch.
- This device is suitable for ANY application from rockets to simple movement detection.
Parts Termasuk:
ArduIMU+ V3 board
- 6 Pin Right Angle Male Header
PRICE : Rp. 900.000
PEMESANAN MELALUI EMAIL (sensor.toko@gmail.com)
No comments:
Post a Comment